How to connect the FBG demodulator using an Ethernet cable for operation

How to connect the OFSCN Fiber Bragg Grating demodulator using an Ethernet cable and establish management and operation:First, connect the demodulator's Ethernet port (ETH) to the Ethernet port of the management computer using a network cable.

 

 

Next, change the IP address and subnet mask of the management computer.
The subnet mask of the management computer should match that of the demodulator. The IP address has four sets of numbers, and the first three sets should match the demodulator's. The last set should be a value between 1 and 254 and should not match the demodulator's value.

For example: If the demodulator's address is: IP: 192.168.3.252 Subnet Mask: 255.255.255.0
Change the management computer's address to: IP: 192.168.3.123 The first three sets match the demodulator's, and the last set is a value between 1 and 254, not matching the demodulator's '252'. Subnet Mask: 255.255.255.0
This establishes the network communication configuration between the management computer and the demodulator.Finally, access the management interface.

Open a browser: Open a browser on the management computer, such as Firefox, Chrome, or Edge.
Access the management address: Enter the demodulator's IP address in the browser address bar to access the OFSCN demodulator management system welcome page and enter the general monitoring list interface.

 
Change the interface display language: Menu > 'Language' Choose the appropriate language (English, Chinese, or other customized language), and refresh the browser page.